Vinyl Picket Fencing in Bel Air & Surrounding Cities

Bel Air sits solidly within our LA County service area. Access to the 90077 zip is via Sepulveda Pass off the 405 or through Mulholland Drive from the Valley side — typically 25–40 minutes from our operation depending on traffic near the Getty Center interchange. Free on-site estimates are scheduled within 2–3 business days of your call. For non-permitted work — post cap replacement, single picket swap, gate hardware upgrade — turnaround is often within the same week. Permitted new installs are on the calendar within 2 weeks of permit approval. Call (660) 999-9960 to get on the schedule.

Flat-lot vinyl picket in Bel Air runs $28–$38/linear ft installed — post, footing, panel, and post cap, all in. Pool-code height at 60" with self-closing gate hardware runs $34–$48/linear ft. Gates are $400–$900 each depending on width and latch configuration. A 150-foot pool enclosure with two gates typically totals $6,500–$9,200, including the LADBS permit pull and HOA submittal docs. Hillside stepped-panel installs add $4–$8/linear ft for grade work. Exact pricing is given at the free on-site estimate — not a range that shifts after you sign. Call (660) 999-9960 or book online.

Yes — the City of Los Angeles requires a fence permit for anything over 42" in the front yard setback or over 6' anywhere on the property. A 60" pool picket fence triggers the requirement every time. The Bel Air Association architectural review needs to be completed before LADBS will accept the permit application — that review typically takes 2–4 weeks. LADBS processing follows in roughly 1–2 weeks. We handle both under California contractor license #1136541: full Association submittal packet (color chip, product spec, fence drawings) and the complete LADBS permit application. The city fee runs $150–$350 based on project scope.

California Health & Safety Code Section 115922 sets a 4" maximum gap between pickets on any fence serving as the primary pool enclosure — measured at the widest point. On a sloped lot, that means continuous panel racking can push spacing past 4" at the downhill end, which fails inspection even if the uphill end is correct. The solution is stepped panel installation with level horizontal runs. Gate hardware must be self-closing and self-latching, with the latch located on the pool side of the gate at 54" or higher. Every pool gate we install uses Magna-Latch MLA3 hardware — ASTM F2200-compliant and built to pass LA County pool barrier inspection without field adjustment.

Panels, posts, rails, and post caps carry a lifetime material warranty covering UV yellowing, brittleness, and structural failure. That warranty runs from the manufacturer — CertainTeed Bufftech or Illusions Vinyl Fence depending on the product spec — and is backed by Secure Vinyl Fencing as the licensed installer. Labor carries a separate two-year warranty. Bel Air's UV intensity is exactly why only virgin vinyl with TiO2 UV inhibitors is specified — calcium carbonate-filler panels chalk and crack in 5–7 years here, often voiding budget-brand warranties on "environmental condition" exclusions. The lifetime coverage does not include impact damage, vehicle strikes, or structural post damage from Santa Ana wind events exceeding 70 mph gusts.

Bel Air is near the center of our LA County zone. Regular coverage includes Brentwood (90049), Beverly Hills (90210), Holmby Hills, Westwood, Benedict Canyon, West Gate Bel Air, and across the Santa Monica Mountains into the San Fernando Valley. Orange County and Ventura County are both within our full service area. New permitted installs in and around Bel Air are typically scheduled 1–2 weeks out; repairs and hardware swaps are 3–5 days. A 5-star Google-rated contractor with 51 reviews, we give exact pricing at every free on-site estimate — no estimates-by-phone that change on arrival. Call (660) 999-9960 to book.